By Jaclyn Mackey on Tuesday, 31 October 2023
Category: Hyperbaric Facility Safety

Part 2.1: Personnel & Management as Contributing Factors in Hyperbaric Facility Accidents

When one commences a task to reconstruct how an accident happened, personnel and management factors are often “at the head of the class.” Some of the more commonly occurring factors are discussed in this section. It should be noted, however, that this list is not all-inclusive. The factors that can contribute to accidents are many and varied. As technology and operations become ever more complex, our ability to create new ways to “do ourselves in” are amazing.

Operator Fatigue

This factor is one of the more common ones. When people get tired, their level of attention to what they are doing decreases. Especially vulnerable is the level of appreci- ation for hazards that cannot be seen. Reflexes and fine motor control deteriorate and sloppiness increases. People become capable of doing stupid things that, when rested, they would never do. Necessary maintenance and other jobs that don’t have immediate necessity also tend to get skipped over. Operator fatigue seems like such an obvious risk factor that everyone in a managerial position should be constantly on the watch for it. However, operator energy is also a limiting factor in the ever-present drive to cut costs and increase productivity. Many employees, as they are asked to do more, will try to keep up until finally they crack, quit, or do something foolish. This is an area where safety and economy are natural competitors, and managerial personnel need to be con- stantly on the alert for signs that operational personnel are being asked to do more than they can be reasonably expected to do without excessive fatigue or stress.

Boredom and Inattention

This risk factor is almost the opposite of operator fatigue. Operators on long watches at stations where there is little to do have a tendency to invent things to occupy their minds. This can create a situation where the early warning signs of an impending prob- lem can go unnoticed until a situation has deteriorated to a point where recovery is difficult. Warning devices are helpful. A typical example of such a device is the wash- board surface that is now commonly added to the shoulders on interstate highways. Whenever possible, a better approach is to design the mental workload for a given posi- tion so that the person’s brain has enough to do to keep it alert. Requiring nonrepetitive voice communications is one remedy that is effective in this area. Students at a boring lecture often perk up smartly when asked to raise their hand in response to a question.

Inappropriate Operator Response to an Otherwise Manageable Problem

This factor is closely related to the following one. Many unexpected situations in the hyperbaric environment do not require an immediate response. The best response is often to DISTURB NOTHING, THINK, and then ACT. If one has a blowout while driving, often the worst possible thing to do is to brake strongly. The same is often true in hyperbarics. The best procedure is usually to stabilize the situation, determine the problem, assess possible corrective actions and their risks, and then proceed. In many situations, 50% or more of the solution to a problem is a correct determination of what the problem is.

Some years ago, two divers died of hyperthermia in a North Sea commercial satura- tion diving operation. The facility operator was monitoring a depth gauge that could be connected to any one of several compartments in the facility. The operator was some- how under the belief that the gauge was connected to the diving bell where the divers were when it was, in fact, connected to one of the deck chambers. The deck chamber developed a large leak. Thinking the bell was losing pressure, the operator added helium to the bell at an ever-higher rate. The comfort zone in a helium environment is very narrow due to its very high thermal conductivity. By the time the operator realized his error, the bell had been quickly pressurized several hundred feet of seawater and the resulting temperature increase in the bell proved lethal to both divers. There were sev- eral accident factors at work in this case. However, chief among them was an operator response that was inappropriate to the problem.

Inappropriate Operator Response to an Otherwise Manageable Problem

This factor is closely related to the following one. Many unexpected situations in the hyperbaric environment do not require an immediate response. The best response is often to DISTURB NOTHING, THINK, and then ACT. If one has a blowout while driving, often the worst possible thing to do is to brake strongly. The same is often true in hyperbarics. The best procedure is usually to stabilize the situation, determine the problem, assess possible corrective actions and their risks, and then proceed. In many situations, 50% or more of the solution to a problem is a correct determination of what the problem is.
Some years ago, two divers died of hyperthermia in a North Sea commercial satura- tion diving operation. The facility operator was monitoring a depth gauge that could be connected to any one of several compartments in the facility. The operator was some- how under the belief that the gauge was connected to the diving bell where the divers were when it was, in fact, connected to one of the deck chambers. The deck chamber developed a large leak. Thinking the bell was losing pressure, the operator added helium to the bell at an ever-higher rate. The comfort zone in a helium environment is very narrow due to its very high thermal conductivity. By the time the operator realized his error, the bell had been quickly pressurized several hundred feet of seawater and the resulting temperature increase in the bell proved lethal to both divers. There were sev- eral accident factors at work in this case. However, chief among them was an operator response that was inappropriate to the problem.

Failure to Practice Emergency Responses

This risk factor has two faces: personnel and equipment.
Personnel who have not practiced an emergency situation have a higher probability of an inappropriate response than those who have. Some unpracticed operators will freeze and do nothing until the time window for situation-saving action has passed. A useful example is a beginner automobile driver and a slippery road. Many drivers on their first loss-of-traction experience will either freeze and do nothing or brake. Both responses usually do a fine job of turning a modest sideslip of the rear wheels into a full-fledged spin. The driver who has practiced a few deliberate spins on a snow-covered parking lot has a much better chance of keeping the car on the road.

Using emergency equipment during practice drills has a twofold advantage. First, the operators get used to the “feel” of the equipment. Secondly, the equipment gets much needed “exercise.” This is particularly true of hyperbaric fire suppression systems, which are high-performance equipment expected to work flawlessly after long periods of idleness. It is not surprising that as the length of idleness increases, the probability of flawless performance decreases.

Pressure to Meet Deadlines and Quotas

Deadlines and quotas are an unavoidable part of life. The pressure to meet them is gen- erally proportional to the perceived cost of missing them. However, rarely is a deadline worth the price of an accident. The same can be said of quotas. In both cases, manage- ment personnel need to carefully monitor their staff for warning signs of fatigue and other risk factors. It is also important for management to create an environment where staff personnel feel safe reporting to superiors when they feel they are being asked to do more than they feel they can safely do.

Outright Operator Stupidity

Given enough operations by enough people, eventually someone will do something consummately dumb. Typical examples are a “gas king” on a saturation diving system sending pure inert gas to a diver and a pilot taking off with too much weight or too little fuel in the airplane. Sometimes, there are steps that can be taken ahead of time to mitigate the effects of these types of errors. In the early days of saturation diving, the inert gas supplies (usually helium) were kept as pure gas. Subsequently, operators have found that a much better practice is to make certain that their inert gas stores always contain a small amount of oxygen, typically about 2%. In that way, if a gas king makes a bad mistake, the results are embarrassing but not disastrous.


Excerpted with permission from the publisher. Source Reference Hyperbaric Facility Safety: A Practical Guide, Second Edition

Learn More About Hyperbaric Facility Safety with our 16-hour CEU Course! Find more details here.

Leave Comments